G.T. Fieros

I think I'm going to tackle taking of my body panels and deal with some rust in my forward wheel wells. The trunk has already been done, but for some reason the PO didn't touch the rest. I've read a bit about POR-15 and how amazing it is for coating metal and stopping rust. I found a place that's down in Grimsby that sells it, and want to know if anybody else has had any experience with the stuff. I want to make sure I've got enough, but don't want to go crazy and spend too much. Basically once I start tearing things down I don't want to stop because I didn't get enough supply. Should I go for the 'quart of each' deal for $90?

http://www.canada-por15.com/merchant.mvc?Screen=PROD&Product_Code=QKSP&Category_Code=Specials

I looked into this a long time ago.

Basically Por 15 it good stuff, but requires a lot of surface prep for it to work well. I found something that was much better and cheaper. It's call Rust Bullet. You can find it here:
http://www.kapcor.ca/Automotive/Automotive.htm

The will show you direct comparisons with Por15 on there site.

.