can you drive it? if so bring it by my "shop" today if you can. I'm going to be in Whitby working on my car. Storage is open noon -5pm.
Sent you an email with address & directions.
| G.T. Fieros http://www.gtfieros.com/phpBB3/ |
|
| braided egr tube http://www.gtfieros.com/phpBB3/viewtopic.php?f=6&t=559 |
Page 1 of 1 |
| Author: | evoauto1979 [ Thu Aug 21, 2014 12:28 pm ] |
| Post subject: | braided egr tube |
I just got a braided egr tube and was wondering. The new tube has a smaller diameter and larger diameter openings. Which one goes where? I didn't receive instructions with it so I'm not sure. The one that came off seems the same diameter on both ends. Thanks for the help |
|
| Author: | NOTCH 8 [ Fri Aug 22, 2014 12:30 pm ] |
| Post subject: | Re: braided egr tube |
The end with the pin hole in the end of the tube goes on intake. |
|
| Author: | evoauto1979 [ Sat Aug 23, 2014 8:04 am ] |
| Post subject: | Re: braided egr tube |
That's what I figured. So it's got a new egr tube, egr valve, plenum gaskets, plugs wires cap rotor and it still runs like crap. Symptoms include idling at 1700 or higher. Give it throttle and it bogs out and then catches. I can hear a wicked vacuum leak on the drivers side. Only thing I haven't replaced is the throttle body gasket as it looked mint. All the vacuum lines look good and so to the elbows/joiners. Any ideas? |
|
| Author: | x-thumpr-x [ Sun Aug 24, 2014 8:11 am ] |
| Post subject: | Re: braided egr tube |
can you drive it? if so bring it by my "shop" today if you can. I'm going to be in Whitby working on my car. Storage is open noon -5pm. Sent you an email with address & directions.
|
|
| Author: | evoauto1979 [ Sun Aug 24, 2014 9:29 am ] |
| Post subject: | Re: braided egr tube |
No plates on it yet and I wouldn't trust her to get me that far. Lol |
|
| Author: | x-thumpr-x [ Sun Aug 24, 2014 10:29 am ] |
| Post subject: | Re: braided egr tube |
Bummer, If you here a hissing, check the lines again for cracks. Also remove the IAC and clean it out with some brake cleaner. Maybe remove the throttle body and give it a good cleaning too, IAC mighty not be closing fully. |
|
| Author: | dougbaker [ Tue Apr 14, 2015 11:13 am ] |
| Post subject: | Re: braided egr tube |
I put small orifice end at EGR and runs fine. Does it matter and where is this documented? The OEM tube had no restrictors? (fyi 86 GT 3.4) |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|