G.T. Fieros • View topic - Where do these wires go

View unanswered posts | View active topics

Board index » Public Forums » Technical Discussions

All times are UTC - 5 hours [ DST ]

Where do these wires go

Page 1 of 1

[ 6 posts ]

Print view

Previous topic | Next topic

Author

Message

dougbaker

Post subject: Where do these wires go

Posted: Mon Nov 03, 2014 9:14 pm

Newbie

Joined: Mon Nov 03, 2014 10:22 am
Posts: 11

'Been so long since I started my 3.4 project that wire tags fell off:
GRN and GRN/YEL coming from sleeve under plenum trunk side toward the distributor. The other wires in sleeve go to condenser, coil and distributor.

Top

Darn cars

Post subject: Re: Where do these wires go

Posted: Tue Nov 04, 2014 12:05 am

Addict

Joined: Sun Nov 24, 2013 11:41 am
Posts: 241
Location: Peterborough Ontario

If they are dark green then maybe the coolant sensor can check by metering back to C500 connector

Top

x-thumpr-x

Post subject: Re: Where do these wires go

Posted: Tue Nov 04, 2014 5:26 pm

Fieronut

Joined: Wed Jan 16, 2013 7:56 pm
Posts: 822
Location: Toronto

sounds like the two wires for the temp gauge and idiot light. left hand side of the head facing the trunk, sensor in the corner there by the coil.

Top

dougbaker

Post subject: Re: Where do these wires go

Posted: Fri May 01, 2015 2:18 pm

Newbie

Joined: Mon Nov 03, 2014 10:22 am
Posts: 11

"What Sensor ?"..and then I notice blank plug on the 3.4 . It would have been soooooo much easier if I installed sensor when the engine was on the stand.

Top

x-thumpr-x

Post subject: Re: Where do these wires go

Posted: Fri May 01, 2015 7:04 pm

Fieronut

Joined: Wed Jan 16, 2013 7:56 pm
Posts: 822
Location: Toronto

dougbaker wrote:

"What Sensor ?"..and then I notice blank plug on the 3.4 . It would have been soooooo much easier if I installed sensor when the engine was on the stand.

Bet you used the stock 3.4L heads too, they are the same as the 2.8L fiero heads. You will need the "green paint" sensor from the Fiero, remove the blank plug on the 3.4L motor and install the sensor. It will sit right but the ignition coil (cylinder 5)

Top

dougbaker

Post subject: Re: Where do these wires go

Posted: Wed Jun 17, 2015 2:34 pm

Newbie

Joined: Mon Nov 03, 2014 10:22 am
Posts: 11

"Remove plug" is a evidently machine shop task that will wait for winter. In the meanwhile BELIEVE IT OR NOT, I attached sensor with hose clamp to a bolt drilled and treaded into the ^$^%$!! plug and temperature gauge works..kinda.

Top

Page 1 of 1

[ 6 posts ]

Board index » Public Forums » Technical Discussions

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 15 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum