G.T. Fieros
http://www.gtfieros.com/phpBB3/

Who needs parts?
http://www.gtfieros.com/phpBB3/viewtopic.php?f=9&t=1042
Page 2 of 2

Author:  BigB [ Tue May 29, 2018 12:49 am ]
Post subject:  Re: Who needs parts?

x-thumpr-x wrote:
I rebuilt the one in my GT no problem.


Hmm, viewing online looked like a very complicated procedure. Guess I'll look again. Thanks Adam.

Author:  BigB [ Tue May 29, 2018 2:25 am ]
Post subject:  Re: Who needs parts?

Found a youtube feed and looks a little clearer. Did you need to purchase the pressure plate compressor and the lock-pin removal tool, or were you able to use something else?

Author:  x-thumpr-x [ Tue May 29, 2018 8:41 am ]
Post subject:  Re: Who needs parts?

BigB wrote:
Found a youtube feed and looks a little clearer. Did you need to purchase the pressure plate compressor and the lock-pin removal tool, or were you able to use something else?


Bought the one tool to remove the ring clip, made my own to remove the two side pins.

Author:  BigB [ Thu May 31, 2018 10:18 pm ]
Post subject:  Re: Who needs parts?

Well, I was quite successful in pulling the steering column apart. Yes the inner bolts are a bit loose but is not my issue. The column base in which the bolts attach is cracked at the back and thus, unless I get it welded, she's a goner.

So you have a manual column available? When you heading out to the unit next?

Author:  x-thumpr-x [ Fri Jun 01, 2018 5:58 am ]
Post subject:  Re: Who needs parts?

BigB wrote:
Well, I was quite successful in pulling the steering column apart. Yes the inner bolts are a bit loose but is not my issue. The column base in which the bolts attach is cracked at the back and thus, unless I get it welded, she's a goner.

So you have a manual column available? When you heading out to the unit next?


I'm heading to storage unit on Saturday.

Author:  jjd2296 [ Sat Jun 02, 2018 8:21 am ]
Post subject:  Re: Who needs parts?

Check for that manifold heat shield

Author:  x-thumpr-x [ Sat Jun 02, 2018 5:25 pm ]
Post subject:  Re: Who needs parts?

jjd2296 wrote:
Check for that manifold heat shield


Hey there, I couldn't find it. it's either gone already or buried in the other unit which is a total mess right now.

Page 2 of 2 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/