G.T. Fieros

If the areo nose is not sagging and in good shape i'll take that.
Also need the ground effect from the panel behind the pass door.

Let me know
thx

_________________
Dougie Murder
1985 Fiero GT...work in progress

Back to storage today to continue stripping car down.

_________________
Forum Admin
87 GT 3400 Green
88T-top: WIP

ok,
front hood to play with,
drivers side front fender
deck lid vents (if no cracks),
wiper arm motor & wiper assembly etc,
power mirror switch, if it has one
alternator,
coolant overflow jug, if not cracked
wiper washer pump,
hubs etc (whatever i need for brake upgrade to either lebaron/grand am),
egr solenoid if good,
iac
vacuum hose/lines, if not brittle
any parts that i may need to do a future 3400/3800 swap on my red gt
if the battery still good, i could use a spare in the garage...


that should be it.
Looks like this thursday is open 4 me to swing by, smaller posibility friday..if that works with u Adam, let me know.

Hoods off
Fendor is off
decklid vents look good
wiper assembly ok
no power mirrors (if it had, I need it )
alternator works/ has sheild
coolant jug has usual crack
wiper pump ok (take hole resivior)
I need the hubs, sold my spare set last summer
EGR solenoid seems to work
IAC OK
motor still in car & it runs, so guessing engine items are good.
3400 swaps I know, 3800 I don't know whats needed.

I will most likely be there everyday this week to get it done by friday.

_________________
Forum Admin
87 GT 3400 Green
88T-top: WIP

Is the radio/heater control bezel going with the interior? I'm looking at putting in a double din deck and would like to have a backup in case I fail miserably

sweet. thanks Adam!

i'll see u thursday then but i'll confirm first with u either wed nite or text u thurs am.
pm me address and what time u think u'll b there on thurs.

if you are reffering to the center skeleton which the radio/ heater control screwed to, it's still in the car and previous owner damaged it while installing an aftermarket radio. It might be better used to make your double din set-up.

_________________
Forum Admin
87 GT 3400 Green
88T-top: WIP

"3800 I don't know whats needed. "


hmmm, anyone know off hand? (will be goin into an auto, series 2 set up...)

in the meantime, i'm guessing here from my poor head memory

axle? i don't recall which side...
thermostat housing?

also, pls add:

dogbone & bracket, if good; rubber doesn't matter
egr valve & tube; if good/no cracks
calipers all around

Thanks for all your help today adam!

If there was a rating system on here you'd have a + from me.

_________________
Dougie Murder
1985 Fiero GT...work in progress

where is this car? i mean if the tranny is up for grabs id take it, the shifter, and linkages for it

Hey X-thumpr-X What shape are the axles in? I dropped by standard Auto Wreckers but to look at their cars axle but the axle looked a mess and the axle nut was so rusted I passed on it. Seeing this car has 340,000 Kms would they also be past there life? If I can't find axles for a standard Fiero for my swap what do I do? Can you get custom axles made?

_________________
SaturnTO
Alliston
Ontario

hey Adam, where's your unit again? i ferget....

Hello
Made progress with the tear down today, but I recently had a set back on another vehicle. Ebrake on my GTP gave out last tuesday & it looks like I need to do a full rear brake job on it. Now I need to come up with cash for this, $300 in parts with me doing the install. Hate to ask what GM would charge to do this when I priced my parts from Rock Auto.

Most of the items I haven't worried about an $$ for but list of items I would like to see some money for:

Axles; they look like they have both been recently replaced
Calipers are in good shape, brakes must like be recent before pulled off the road
Transmission: vehicle drove fine around my unit & been told the clutch was recently replaced. (Clutch, master & slave can go with it)
Cradle (will inspect first to make sure it's in good shape after drivetrain removed)
Lower rad support ( once I have the D-plate off I will have a better look at it but front of car looks in good shape beside bumper)
Gas tank
front cross member ( willing to pull it off in once piece less the front rotors)

Front of this car was very well kept and properly under coated, to bad the rear had to be in such bad shape, car was rear ended, trunk caved in and looks like they didn't properly uncoat the rear of the car since the accident.

A few of these item have recently been asked for & I haven't had a chance to post this up yet before people started enquiring.

My unit is here, but make sure you get a hold of me first to make sure I'm there
I will be there tuesday morning for roughly 9am to continue dismantling and cutting.



Z custom, you can have the shifter & cables, tell you though a previous owner decided to glue the knob in place for some reason.

_________________
Forum Admin
87 GT 3400 Green
88T-top: WIP

Nice how much for the axles Adam?

_________________
SaturnTO
Alliston
Ontario